Controller Boards Section
 |
|  | Board of Education - Full Kit USB from Parallax
This kit contains
Board of Education - USB Interface,
BASIC Stamp 2 Module, pluggable wires, USB cable, cd-rom, and power supply. This is the basic set of materials you need to begin developing with the Basic Stamp. Beginners should consider
BASIC Stamp 2 Discovery Kit USB to get a complete set of printed documentation and an introductory learning kit. Manufacturer: Parallax. Manufacturer's Part Number: 28802.
More Product Details ...
| | | |
|
| |
|  | Board of Education - Full Kit Serial from Parallax
This kit contains
Board of Education - Serial Interface,
BASIC Stamp 2 Module, pluggable wires, serial cable, cd-rom, and power supply. This is the basic set of materials you need to begin developing with the Basic Stamp. Beginners should consider
BASIC Stamp 2 Discovery Kit to get a complete set of printed documentation and an introductory learning kit. Manufacturer: Parallax. Manufacturer's Part Number: 28102.
More Product Details ...
| | | |
|
| |
|  | Parallax Professional Development Board from Parallax
he Parallax Professional Development Board (PDB) is high-quality, fully-integrated development platform for BASIC Stamp, Javelin Stamp, and Ubicom SX28AC/DP microcontrollers. A wide variety of typical I/O (LEDs, LCD interface, buttons, etc.) devices and circuitry are built into the PDB, providing developers with an ideal platform for rapid project development. Three sets of sockets are provided that allow the PDB to accommodate BS1-IC module, 24 and 40-pin BASIC Stamp modules, Javelin Stamp modules, and the SX28AC/DP microcontroller. The SX28 socket is mechanically separated from the other modules and allows the SX28AC/DP to run with all BASIC Stamp and Javelin Stamp modules except the BS2p40.
Features:- 40-pin DIP socket (for all BASIC Stamp 24/40-pin and Javelin Stamp modules)
- 14-pin SIP socket (for BS1-IC)
- 28-pin skinny DIP socket (for SX28AC/DP)
- USB, DB-9, BS1, and SX-Key programming connectors
- 2.1 mm, center-positive connector for DC power
- 5 volt, 1.0 amp power-supply with power switch
- 16 discrete blue LEDs
- Five blue 7-segment (with decimal point), common-cathode LED displays
- Parallel LCD (available separately) may be configured in 4-bit or 8-bit mode
- Two servo-compatible headers
- Two 10k Ohm potentiometers
- Audio amplifier with built-in speaker; with switch for external speaker
- L293D high-current driver for motors, solenoids, etc.
- Eight, normally-open pushbuttons (I/O lines protected, and pulled-up to Vdd via 10K)
- Eight DIP switches (I/O lines protected, and pulled-up to Vdd via 10K)
- Pulse generator with selectable frequency (1 Hz, 10 Hz, 100 Hz, or 1 kHz)
- RJ-11 connector; configurable for X-10 and 1-Wire communications
- RS-232 DCE port with MAX232E transceiver
- DS1307 (I2C) real-time-clock with 3v back-up battery (pre-installed)
Does not include Basic Stamp module, USB cable, serial cable or power supply. We recommend a 12V, 1A power supply such as
AC Power Adapter 12 VDC to support the widest range of potential uses. Manufacturer: Parallax. Manufacturer's Part Number: 28138.
More Product Details ...
| | | |
| Stock Number | Buy | Product Title | Price | Status | |
H02111-01G |
 | Parallax Professional Development Board | $149.00 | In Stock |
|
|
|